An approach to the application of additive manufacturing for water environments: a case study to measure dissolved carbon dioxide

Authors

  • Iván Ibáñez Felip
  • Rosario Vidal Nadal

DOI:

https://doi.org/10.5821/iwp.2023.22.14730

Abstract

This paper describes the design of a case for the grouping and protection of the elements required for the quantification of dissolved carbon dioxide, allowing measurements to a depth of 10 meters. The possibility of implementing additive manufacturing (AM) technologies to reduce the production cost and design capabilities of the system is studied.

Issue

No. 22 (2023)

Section

Articles

License

Universitat Politècnica de Catalunya has joined the Berlin Declaration on Open Access to Knowledge in the Sciences and Humanities. This declaration proposes the universal acces to the results of scientific and technical research.

All papers presented at Martech will be published in both the UPCommons and the Martech organization web sites, the former being the institutional digital deposit of Universitat Politècnica de Catalunya (https://upcommons.upc.edu). This difussion will be made through the Creative Commons License Attribution-NonCommercial-NoDerivs 2.5 or similar (http://creativecommons.org/licenses/by-nc-nd/2.5/deed.en).

When sending the final paper, the author must agree to the conference having non-exclusive rights on this operation. The author will maintain his/her right to diffuse the paper elsewhere.